Forum Message

 

 

We have moved the forum to https://forum.ngsolve.org . This is an archived version of the topics until 05/05/23. All the topics were moved to the new forum and conversations can be continued there. This forum is just kept as legacy to not invalidate old links. If you want to continue a conversation just look for the topic in the new forum.

Notice

The forum is in read only mode.

Submitting patches

More
7 years 2 weeks ago #10 by Kunda
Submitting patches was created by Kunda
Where can they be submitted ?
More
7 years 2 weeks ago #11 by joachim
Replied by joachim on topic Submitting patches
Hi,

thank you for your support. It depends on:
* if it's a small fix, send it by mail to joachim.schoeberl (at) tuwien.ac.at, or the other developers.
* if you are going to contribute more patches over time, we will add you to the (netgen and/or ngsolve) gitlab projects

- Joachim
More
7 years 1 week ago #12 by Kunda
Replied by Kunda on topic Submitting patches
@joachim thanks. Are the gitlab repos publicly accessible ?
More
7 years 1 week ago #13 by joachim
Replied by joachim on topic Submitting patches
Hi Kunda,
we have our local gitlab with many development branches, which are not public. We can give you access to it.
We push the master-banch to the git on sourceforge, where everyone can clone from.
Joachim
More
6 years 11 months ago #14 by Kunda
Replied by Kunda on topic Submitting patches
@joachim here is another patch:
raw.githubusercontent.com/looooo/FreeCAD...ld_without_gui.patch

It was created by a user named looo in the FreeCAD community who uses Conda to build FreeCAD.
More
5 years 7 months ago #665 by Kunda
Replied by Kunda on topic Submitting patches

joachim wrote: Hi Kunda,
we have our local gitlab with many development branches, which are not public. We can give you access to it.
We push the master-banch to the git on sourceforge, where everyone can clone from.
Joachim


Hi @joachim
There are a few of us over at FreeCAD that would appreciate access to the gitlab dev repos, if that is still an option?
Time to create page: 0.190 seconds